Utah Symposium '02 - The Day Before


Petter showed the advantages (and improper use dangers) of hollowing with these tools	Proper presentation for the cut start is 90% of the battle	The tool can make short work of hollowing if properly used	Keeping it sharp is relatively simple using diamond hones for the inside ...

and the outside of the ring tool	Some examples of work out for display in the power carving demo booth	These pieces were obviously done by a very talented professional	While these pieces had no prices attached, they range ...

from hundreds to thousands of hours to complete	This jewelry box is as exquisite on the inside as well	Another jewelry box	This box was reported to have 4000 hours of labor in it

This flower vase was about 16 inches tall ...	as was this beautiful vase	A couple of close-ups of Lyle Jamieson's hollowed torso carvings ...	that were displayed in his demonstration area
Go to page 1	Go to page 2	Go to page 3
Go to page 5	Go to page 6	Go to page 7	Go to page 8
Go to page 9	Go to page 10	Go to page 11	Go to page 12

Photos by Kurt Hertzog

Questions or comments? Check our FAQs or Contact us
Rochester Woodworkers Society, Inc. Ó 2000-2008
This page last updated on 07/10/2008 RWS ByLaws Privacy Statement Editorial Policy Website Credits