Home   Events   Newsletter   Library   Classifieds   Gallery   Links   Contact Us   Join RWS  FAQs

David Wright Workshop (3/5)

David explains the goals for the leg turnings	No measurements, David uses a "story stick"	Creating a leg	A little peer review?
David finishes up a leg	The workshop was held in the 3D shop at RIT	Sharp, crisp edges - no sanding	Test fitting the legs
David explains proper "hole to grain" relationship	Adjusting the drilling jig for the proper angle	The best drill bit, however no longer available	A good view of "off the tool" leg finish
Leg and spreader ends being dried	These dimensions are important	Beginning assembly	The spreader assembly
David's Wksp - Page 1	David's Wksp - Page 2	David's Wksp - Page 4	David's Wksp - Page 5
Photos by Kurt Hertzog

Home   Events   Newsletter   Library   Special Interest Groups    Join RWS
Classifieds   Gallery   Links   Members   Archives   Sponsors
 

Questions or comments? Check our FAQs or Contact us
Rochester Woodworkers Society, Inc. Ó 2000-2008
This page last updated on 08/19/2008   RWS ByLaws    Privacy Statement   Editorial Policy   Website Credits